The clock setting icon flashes when you are setting the time. The time decrements or increments follow by a faster rate when you press and hold the button. Press > on the top of the unit to set the clock time.Press SET on the top of the unit until the clock setting icon flashes on the display.Setting clock manually: In case the memory holding batteries are accidentally removed, set the clock manually as below: WARNING: Please avoid playing with these buttons after entering the Clock/Alarm set mode. Your clock is now set and ready for use.The selected time zone shows on the display briefly with TIME ZONE icon flashes on the display. Select your time zone: Press TIME ZONE repeatedly on the top of the unit to cycle through the time zones (EST > CST > MST > PST > AKST > HST > AST > EST.).A confirmation message (on) or (off) shows on the display when you make a selection. Select daylight saving: Press and hold DST on the top of the unit to turn on/off in areas observing/not observing such time change.Plug for power: Insert the plug of the unit into an AC power outlet.After AC power is restored (reconnected), the Digital Display will blink to indicate that power was interrupted and you should readjust the time and alarm settings.Īuto clock set: You do not have to set the clock time as a built-in automatic time set system is equipped in this clock powered by 2 AA batteries (included and installed). Power failure indicator: When AC power is interrupted (disconnected) for a short period of time, both time and alarm settings will change (unless battery is installed). It is recommended to plug the unit for AC power while replacing batteries to avoid the loss of clock and wake time/mode settings.
It is recommended that you replace the batteries every year.Remove battery compartment door (located at the bottom of the radio) by applying thumb pressure to the tab on battery door and then lift the door out and off the cabinet.Normal operation will resume after AC power is restored so you will not have to reset the time or the alarm. When the battery backup functions, the digital display will not light, however, the function of alarm still occurs during the power interruption if remaining battery power is adequate. When normal household power is interrupted, or AC line cord is unplugged, the batteries will power the clock radio to keep track of time and alarm settings programmed into memory. The power failure protection circuit will not operate unless battery is installed. Operating the RCA RC65I Clock Radio w/ iPod Dockīattery back-up operation: This clock radio is equipped with a memory holding system that can be powered with 2 “AA” batteries (included and installed).
0 kommentar(er)
